Operating instructions

Dole – Drivers Reference Manual
Page 36
e) If the engine fails to start, snap the on/off switch to the OFF position, press the reset
switch and repeat steps (b) through (d).
3.5.4 Illustration of the
Thermo King SGCM 2000
NOTE: Before starting the generator set,
make sure the refrigeration unit power
cord is connected to the generator set
electric power receptacle.
a) Turn unit On/Off switch to On.
b) The delay screen counts down from 11 to
01 while the controller performs some self
checks.
c) The controller energizes the air heater for preheat. The preheat buzzer is energized
during the preheat period. Preheat may continue until after engine starts.
d) If the engine fails to start, place the unit switch in the Off position. Determine and
correct the cause of the starting failure. Then repeat the starting procedure.
NOTE: NEVER USE STARTING FLUID. PLEASE REFER TO STARTING
INSTRUCTIONS TO THE RIGHT OF CONTROL PANEL ON GENSET.
3.5.5 Illustration of the
Thermo King SGCM 3000
NOTE: Before starting the generator set, make sure the refrigeration unit power cord
is connected to the generator set electric power receptacle.
a) Turn unit On/Off switch to On.
b) The delay screen counts down from 11 to 01 while
the controller performs some self checks.
c) The controller energizes the air heater for preheat.
The preheat buzzer is energized during the preheat
period. Preheat may continue until after engine
starts.
d) If the engine fails to start, place the unit switch in
the Off position. Determine and correct the cause of
the starting failure. Then repeat the starting
procedure.