Now With ESCORT Inc. 5440 West Chester Road West Chester OH 45069 800.433.3487 www.EscortRadar.com ©2014 ESCORT Inc. Escort®, Passport®, AutoSensitivity™, SpecDisplay™, ExpertMeter™, and Laser ShifterPro™ are trademarks of Escort Inc. SWS™ is a trademark of SWS LC. Features, specifications and prices subject to change without notice.
PASSPORT 9500ci Comes Complete Front Radar Receiver • Miniature weatherproof radar receiver • Two universal mounting brackets with stainless steel hardware • Built-in 3-foot cable with waterproof connector • 13-foot cable with waterproof connector and inline grommet • 12 nylon wire ties to secure cable Front Laser ShifterPro Sensors • Twin weatherproof sensors • 19.
Important Notes Read This First Installation Instructions Important Installation Warnings For the easiest, trouble-free installation, install the interface first and wire it to a 12-volt switched circuit. 1 It is recommended that you have a professional install your new PASSPORT. Installation of this system requires experience and expertise in automotive electronics. If you are unfamiliar with automotive electronics, car audio specialists and many car dealers can install your PASSPORT for you.
A Interface B Front Radar Receiver White Stripe Front Radar Receiver (Continued) 5 Find a suitable entry point into the vehicle’s interior. Refer to the Installation Tips section. 1 Install the Interface under the dash using supplied zip-ties. Note: Do Not Mount In Engine Compartment. 2 Connect black wire (-) to ground, and red-striped wire (+) to a switched 12-volt supply. (If PASSPORT is left in the “on” position, it will automatically power on and off with the ignition).
Installation Schematic Overview I Letter References For Components (Color Coded Connections To Interface) A Interface B Front Radar Receiver (White Stripe) C Front Laser ShifterPros (Plug ShifterPro Sensors into ShifterPro Bridge Box ports D1) D ShifterPro Bridge Box (Plug D2 of Bridge Box into either Front Shifter port of 9500ci Interface) E GPS Antenna (Yellow Shrink) I Powered Speaker F Display Module (Orange Shrink) J Radio Mute G Control Module (Blue Shrink) H Concealed Alert Indicator (Gray Shrink)
Front Laser ShifterPros (Continued) Individual Sensor Installation 1 Using bolts, nuts and washers, mount sensor to supplied L-shaped bracket and tighten firmly. 2 Using screws, mount L-shaped bracket (with sensor attached) to solid surface of vehicle grill. 3 Use supplied bubble level to check alignment of the sensor and ensure it is parallel to the road. 4 Repeat for additional sensor(s).
F Display Module Orange Shrink 1 Determine the best location for the Display Module. If installed by a professional, the customer should be consulted. An optimal location is clearly visible from the driver’s position and does not take a driver’s eyes off the road for more than a moment. Display Bezel Mounting Display Bezel Mounting (Continued) 1 The supplied display bezel can be used to mount the Display permanently in the dash or console.
H Concealed Alert Indicator Gray Shrink I Operation Test Powered Speaker After all components are installed correctly: 1 Turn PASSPORT on by turning on the vehicle’s ignition and, if necessary, press the power button on the Control Module. 1 Determine the best location for the Alert Indicator. If installed by a professional, the customer should be consulted. An optimal location is clearly visible from the driver’s position and does not take a driver’s eyes off the road for more than a moment.