Manualshelf

Installation Instructions

ManualsBrandsEscort ManualsAutomotiveRadar Detector with BLE
10111213141516171819
13 | Page
AutoPower
This feature automatically turns off MAX 3 after a set period of time to save unnecessary drain
on your battery. This is especially useful if your vehicle has a constant-power ignition. To turn
MAX 3 on again you must press the power button.
Note: If AutoPower is on, to save screen life the display screen goes blank after 30 minutes
without moving. The display screen will turn on automatically after you reach 10MPH.
Band Enables
In the factory default setting the suggested radar and laser bands for North America are
monitored and sources of some common false alerts are rejected. It is highly recommended
that you use your MAX 3 in this mode.
If you modify Band Enables then this setting will show Modified. The MAX 3 will also notify you
during the startup sequence with an audible alert.
WARNING: Do not turn off any bands unless you are absolutely certain there are no traffic radar
guns using that specific band in your area.
Shifters
(only displayed when ZR5 or ZW5 shifters are connected)
When MAX 3 is connected to ZR5 or ZW5, the MUTE button can be used to manually shut off
Laser Shifting once you have checked your speed. Since some laser guns provide “jamming”
codes for the officer, this can be useful to avoid any undue attention. Simply press the MUTE
button twice during a laser alert. All Shifters will cease to transmit and the display will change
from “Shifting” to “Laser”. “Laser” indicates that you are receiving a laser alert in “Receive
Only” mode.
The Shifters will remain in the “Receive Only” mode for approximately thirty seconds, giving
you time to pass the speed trap. Once this time has expired a double beep tone will be given,
indicating that the Shifters are now back in “Shifting” mode.
Marker Enables
In the factory default setting, the suggested fixed location alerts are reported. It is highly
recommended that you use your MAX 3 in this mode.
If you modify Marker Enables then this setting will show Modified and only the Markers that
you have selected are reported.