AUTOMATIC DIGITAL WALL MOUNTED INFLATOR Operating Instructions MODEL 10965
1. Thank you for selecting this ESCO Automatic Digital Wall Mounted Inflator. Please read this manual before carrying out any installation or service procedure. 2. This manual is an integral and essential part of the product, please keep it away from damp, heat, dust, oils, do not remove, tear or amend any parts of the manual for any reason. It must be made available to the operator and to maintenance personnel, also to ensure staff training. 3.
INSTALLATION WARNING 1. Unpack the unit. To avoid the risk of personal injury, especially to the eyes, face or skin, DO NOT direct the air stream at any person, or any part of the body. 2. Hold the unit up on the wall and mark where the four (4) holes are to be drilled. 3. Secure the unit using suitable fastener. 4. Connect the air supply to the unit. 5. Connect the rubber hose as air outlet. 6. Connect the power supply. Warning: 1.
PRODUCT IDENTIFICATION 1 CONTROL PANEL 2 3 4 1. Mounting Point (x 4) 2. - Target pressure control 3. + Target pressure control 4. Display 5 5. FLAT TIRE / CONFIRM Flat tire mode air Start/Stop control; Function Select Confirm 6 6. Unit Option Unit of measure select; Over Pressure Setting set control Fig. 1 Control panel CONNECTIONS 7. Power cable 8. Pressurised Air Inlet 9. Air Hose Outlet 10. Exhaust Plug 7 8 9 10 11 11. Buzzer (Audible Warning) Fig. 2 Connections 12 13 DISPLAY 12.
Inflation and Deflation: 1. Press + or - to select target pressure. 2. Connect with tire, ensure no air leaks, inflator will start automatically. 3. When inflation is finished, the tire inflator will stop automatically and BEEP to warn users that inflation has reached target pressure. 4. Disconnect the air hose from tire. • • • • kPa - kilo-pascals bar psi - pounds per square inch kg / cm2 - kilograms per square centimeter Once the unit is set here, it will become the default unit for following usage. 1.
troubleshooting Problem Possible Cause Solution Air leak Leak in the connection Check the pneumatic connection and make sure of seals The inflator works, but no air inflated Obstruction in the filters or in air system Clean the filters and check the air tube Air hose improperly connected Check the hose connection, make sure that no air leaks Tire pressure is below 0.2 bar (3 p.s.i.
Calibration Certificate This Digital Wall Mounted Inflator has been calibrated in its normal working position on test equipment with an accuracy that is traceable to International Standards according to: 86/217/EEC Allowable Tolerance ±0.08 up to and including 4 bar BAR ±0.16 between 4 bar and 10 bar inclusive ±0.25 greater than 10 bar ±1.2 up to and including 58 psi p.s.i. ±2.3 between 58 and 145 psi inclusive ±3.
SPECIFICATIONS Case Die cast aluminium enclosure Degree of protection IP66 Dimensions 23L x 27W x 8.5H cm Shipping weight 13 lbs. | 5.5 kg Inflation range 145 psi / 0.5 - 10 bar (1000 kPa / 10 kg / cm2) Accuracy ±0.3 psi | ±0.02 bar Max. inlet air supply 150 psi | 10.
