User`s manual

PAGE 23
FireBall™ E2 User’s Manual
Connecting Pioneer CD/DVD Changers (CDs Only)
FireBall requires that you connect each changer to the back panel using audio and control cables.
Follow these steps to connect your Pioneer DV-F07 changers to your FireBall:
1. A custom RS-232 serial cable with 9 pin and 15 pin connectors is required to connect the DV-F07 changer to the FireBall.
These can be purchased from your Escient dealer.
2. Connect one end of the RS-232 serial cable into Communication Port number 1, on the back of your FireBall.
3. Connect the other end of the RS-232 serial cable into the “Interface Connector” port on the back of your changer.
4. Locate the stereo RCA audio patch cable that came with your changer.
5. Connect one end of the RCA audio cable into the Analog In jacks number 1 on the back of your FireBall
6. Connect the other end of the RCA audio cable into the Analog Audio Out jacks on the back of your changer.
• If you have more than one changer, repeat these steps to connect the additional changers to communications ports and audio jacks 2 and 3
respectively.
• For the best audio quality, you should also connect digital optical or coax audio cables (not included) between your changers and FireBall.