User`s manual

2.3
Camera Rear Panel
DC POWER INPUT
This two pin connector is the power input for the camera. The power
supply voltage should be between 12 and 28 volts DC measured at the
connector on the camera rear panel. The current draw is a maximum of
0.8 amps at the lowest input supply voltage and 0.3 amps at the highest
input supply voltage.
WARNING
Reversing the polarity of the DC voltage input or voltage levels in excess of 30
volts may permanently damage the camera.
AIA INTERFACE
This is a 68 pin, high density, dual row, D type connector that connects
the camera to a frame grabber board and a serial communication inter-
face for camera control. The frame grabber board processes and displays
digital 0video from the camera. A complete technical description of the
connector and the signals that it carries is contained in chapter four of
this manual.
VIDEO OUTPUT
A BNC type connector provides a 1 volt peak to peak video signal output. This
output is intended to drive a coaxial cable terminated in 75 ohm to ground at the
receiving end. The video output can be user configured for CCIR or RS170
video standards. See the VFR command on page 3.6 of this manual.