User manual

ES220 IP Phone
www.escene.hk
Escene Communication
-SIP2: the secondary SIP , When the primary server is
unavailable ,use the SIP server
-Refresh time: Registration refresh interval, the minimum value is
20 The default value is 3600.
-Con type :UDP or TCP, usually select UDP
-Amount of used line :the account use one line or two lines.
--5) Set up the above parameters, select “Save” to saves settings,
Complete the account creation.
* Note: the parameters with the * mark must be set.
Disable sip account
--1) Select “System setting” > “Advanced setting”；
--2) Enter the password required（The default is empty) ；
--3) Select “SIP” > “Account sip”；
--4) Select “Enable account” > “Disable”；
--5) Select “Save” to saves settings
Network Setting
If you want to … Then…
LAN Port --1) Select “System setting” > “Advanced setting”；
--2) Enter the password required（The default is empty) ；
--3) Select “Network>LAN Port”, you can configure the following
parameters:
-Type: static IP or DHCP or PPOE
-IP: enter IP address , Note: Do not duplicate the IP address with
other devices on the network
-Mask: enter appropriate sub mask
-GW: enter appropriate gateway
- DNS1: enter IP address of the primary DNS server
- DNS2: enter IP address of the secondary DNS server
-Web port: the default Web port is 80,if you change it(for example