User Manual
5.3 BATTERY REPLACEMENT
1. Remove the bottom panel by removing the four M5 screws
2. x2 Foam Pads should be removed from enclosure prior to removing
battery pack
3. Battery pack should be taken out of the frame prior to disconnect
procedure. Once there is sucient space to reach the connectors (XT60,
XT30 connectors), they should be disconnected
4. Install the new battery pack by connecting XT60, XT30 connectors to
the wires protruding from the enclosure, tidying them away and slotting
the battery pack into the frame enclosure
5. Insert and position x2 Foam Pads back to where they were prior to
removing them
20
Foam
Pads
Battery
Pack
XT60
Connector
XT30
Connector