Installation manual

630167_5_Manual_Installation_US_R-emotion
1.0 Product Description:
The Escea ST900 decorative gas fireplace is designed to be built into a cavity. The
appliance is flued via Simpson Duravent Direct Vent Pro 5” x 8” Flue, or compatible
equivalent. The user will control their fireplace with the Radio Frequency (RF) remote. The
glass on the front of the appliance is considered a working surface, and as such care
should be taken not to touch this while the appliance is running as it will get hot.
WARNING:
Failure to follow these instructions could cause a malfunction of the fireplace, which,
could result in death, serious bodily injury, and/or property damage. Failure to follow
these instructions may also void insurance cover and/or product warranty.
Installation:
Installation must be carried out by a registered installer who, on completion of the
installation, must issue a certificate of compliance, in accordance with national and/or local
codes. If a certificate of compliance is not issued then the Escea warranty may be void.
Warranty Repair and Annual Servicing:
Warranty repair work must be carried out by a recognised Escea gas fireplace service
agency. It is recommended that recognised Escea Gas fireplace service agencies are also
used to carry out annual servicing requirements (particularly during the warranty period).
For contact details of authorised Escea service agencies in your area, please contact the
retailer from whom the appliance was purchased.
This product must be installed according to these instructions and in compliance with all
relevant building, gas fitting and other statutory regulations (eg. ANSI Z223.1/NFPA 54). Any
shortcomings in the appliance and flue installation will be the responsibility of the installer,
and Escea will not be accountable for any such failings or their consequences.
35 ”
2
1
17 ”
16
13
17 ”
16
13
13 ”
16
15
2 ”
16
7
22 ”
16
13
44 ”
16
7
15 ”
16
5
21 ”
2
1
13 ”
4
3