Installation manual

630288_0_Manual_Installation-Service_ST900_AUS NZ
6
FERRO / MOLARIS
Go to section 2.1
VELO
Go to section 2.2
1.0 Product Description:
The Escea ST900 decorative gas fire
is designed to be built into a cavity.
The appliance is flued via Simpson
Duravent Direct Vent Pro 5”x8” Flue,
available from your Escea distributor
or retailer. The user will control their
fire with the Radio Frequency (RF)
remote.
2.0 Creating the Cavity:
The cavity specifications vary depending on fascia type. The dimensioned drawings in the
following sections show the size of opening that must be created to fit the ST900. The wall
directly above the fire should be finished / gibbed / lined after the fire has been installed,
unless there is an access hatch or the chase is open to the ceiling cavity, which allows the
flue to be installed after the wall has been lined.
The wall and framework in front of the flue must not exceed 100mm in thickness, this
includes plaster board or any wall linings. This is to ensure there is at least 25mm gap
between all fluing components and any combustible material.
ONLY AVAILABLE
IN NEW ZEALAND