Installation manual

630288_0_Manual_Installation-Service_ST900_AUS NZ
24
15.0 Placing the Fuel Bed Media:
Your ST900 Gas fire will be supplied with a Fuel Bed kit. Follow the instructions below for
the Fuel Bed kit that applies to you. USE only fuel bed media approved by Escea.
15.1 Driftwood Fuel Bed:
First scatter one layer of the supplied white stones evenly across the base of the firebox,
ensuring there are no stones or driftwood pieces inside the pilot flame surround guard.
Arrange the supplied driftwood pieces exactly as shown in the diagram and photo below.
Underneath each piece of driftwood is a written number which will help in correctly
positioning it within the firebox.
15.2 Coal or Glass Fuel Bed:
Scatter the supplied fuel bed media evenly across the base of the firebox, ensuring there
are no coals, glass or media inside the pilot flame surround guard which may obstruct or
impair the pilot assembly.
Ensure no coals, driftwood, glass, or other material are inside the pilot flame
surround guard, and the pilot flame is clearly visible. If any loose material is inside
this guard it may interfere with the pilot and ignition system.