OUTDOOR GAS FIREPLACE USER GUIDE North America 630165_2 EF5000 www.escea.
Any service work carried out on this appliance must only be done by a recognised escea technician or authorized personnel. The data plate for this appliance, containing technical information and specifications, can be found to the right of the control tray, near the base of the fire. To access this, the fascia must be removed. The area surrounding the appliance must be clear and free from combustible materials, gasoline and other flammable vapors and liquids.
Contents Basic Operation 1 Removing the Fascia 4 Replacing Batteries 5 Cleaning and Maintenance 6 Warranty Information 7
Basic Operation The EF5000 is operated by the touch control located on the Right hand side outer edge of the fascia. The basic operations possible from the touch control are ON/OFF and manual adjustment of the flame height. Before operating the fire, switch the Battery Isolating Switch on. Flame Up On / Off Flame Down Ignition: To turn on the fire push the ON/OFF button on the touch control.
Basic Operation Turning on the main burners: Once the pilot flame has been running for 6 seconds press the FLAME UP button to release gas to the two main burners The EF5000 has 4 flame positions: PILOT flame only, LOW burner flame, MEDIUM burner flame and HIGH burner flame. Adjusting the flame height: While the fire is on, push the FLAME UP button or the FLAME DOWN button to increase or decrease the flame height.
Basic Operation
Removing the Fascia The EF5000 Stainless Steel fascia is attached to the fire by four 'hooks' on the corners of the fascia. If you need to remove the fascia, first give the fascia a brief lift upwards as shown. Now pull the fascia towards you, and rest the Fascia on the brackets half way down the firebox, or on the ground while you unplug the two cords connecting the fascia to the fire. Brackets to rest the top fascia hooks on while disconnecting the control cords.
Replacing Batteries The EF5000 uses 3x D sized batteries, To access the battery pack you will need to remove the fascia (as described on previous page). When the fascia has been removed, you will find the battery pack located in the lower middle of the fire, situated inside the control box. Remove the cap of the battery pack, turn it anti-clockwise until it stops, then pull. The batteries inside should slide out.
Cleaning your EF5000 Note: Always ensure the fireplace is cold before starting any cleaning or maintenance. To clean the glass and stones in the front stone tray, first remove the stones from inside the tray and the glass will then be free to slide upwards. The glass can be cleaned using standard window cleaner. The quartz stones can be washed using soapy water To clean the weather cover warm soapy water should be used.
Cleaning your EF5000 For Stainless Steel Fascias: 1. Ensure that the Gas Fireplace is off, and that the fascia is cold. 2. Using the gloves provided with your fascia, remove the towelette from the sachet and wipe the fascia with even, straight strokes. 3. Make sure your strokes follow the direction of the grain or brush finish. Wiping across the grain can leave small scratches. 4. The wipe will leave a very fine film over the fascia, ensure this film is distributed evenly. 5.
LIMITED WARRANTY: Provided that the Product is installed as per ESCEA's Installation Manual and the step by step warranty procedure has been followed as per instructions issued by ESCEA, (documented in the Dealer Manual), and the product is operated and maintained in accordance with ESCEA operating and maintenance instructions, then for the first period of twelve (12) months from the date of purchase ESCEA will pay to the dealer who sold the appliance, a pre-determined sum to repair or replace any part of t
