Service manual

B
ACDEFG
SERVICE
44
S4 Checking Operating Pressure
WARNING: The regulator that is supplied with the re MUST NOT BE REMOVED.
Removal of the regulator, or replacing it with one not intended for use with an Escea re,
will void the limited appliance warranty.
By law, the original installer has supplied a test point prior to the appliance. With all gas
appliances within the house running on full, including this DX1500, check the inlet pres-
sure upstream of the appliance. It must conform with the table in section E8.
To check the operating pressure, with one burner
removed only place your Manometer hose onto
the jet spigot as shown. Ensure you place the
manometer well away from the other burner as
this will get hot.