Service manual

ACDEFG

SERVICE

S3 Cleaning the Fuel bed and Glass

ALWAYS USE GLOVES WHEN HANDLING THE FASCIA AND GLASS.

NEVER RUB THE FASCIA.

The outside of the fascias must only be cleaned with a clean damp cloth, dry o after

cleaning. The high temp silver powder coating that is used on Escea fascia parts contains

certain amounts of aluminium that when rubbed too hard will oxidise leaving a black

smudge that cannot be removed. Always clean when cold.

This is a service procedure that will need to be carried out whenever soot builds up on

fuelbeds and/or inside of glass.

If soot build up becomes excessive or regular then one of the following actions may be

required;

• Reset gas pressure, pressure may be too high;

• Reposition fuelbed, check with specic fuelbed instructions for details;

• Clear any blockage from primary aeration port of burner;

• Check ue tube is not damaged or disconnected.

• Check exhaust fan is operating and cowl is not blocked in any way.

Step 1: Remove fascia panel (if tted) by pulling it from

the wall.

Step 2: Removing the Glass

Using the supplied 3mm Allan Key (hex drive) unscrew

the bolts around the glass retainer.

Take care that the glass and frame does not fall forward

at this stage. Pull the top of the frame toward you slightly and lift the glass and frame out

and away from the re. Ensure to hold on the glass, and take care that the glass does not

fall from the frame. Place the glass & frame carefully aside - This is a two person lift.

Step 3: Take out fuel bed and gently clean away any soot from fuelbed with a soft hearth

brush. The burner tops and fuel media tray can be vacuumed to remove any excess mate-

rial.

Step 4: Clean the inside and outside of glass with normal glass cleaning products. Use a

CLEAN DRY cloth only. Stubborn marks may be cleaned with a ceramic glass cleaner.

Step 5: Reinstate fuel media and glass and test run heater.

NOTE WHEN REPLACING THE GLASS:

When replacing the glass, note that the metal ange shown

to the right must be on top (not the bottom), or the glass will

not t correctly to the replace.