Service manual

B
ACDE
F G SERVICE
36
F5 Locating Wall Mount Cradle for Wireless Control
The appliance’s remote contains the thermostat that will sense the room temperature
and communicate this back to the heater via radio frequency.
A wall mount cradle has been provided for the wireless control and where possible the
control should be housed in this cradle.
The location of this cradle should be decided by
taking into account the following factors;
 Simple, convenient access for the user
 Away from air ow and drafts through the
room
 The parts of the room that people are likely to
spend time
 Away from direct sun light
 A suitable distance away from the heater
 Ideally 1.2m to 1.5m from the oor
The radio frequency signal will go through some
walls but for best results Escea suggest that the
cradle position is less than 10 metres away from
the heater.
The best height o the ground to locate the cradle is about chest height. This gives a
good average room temperature and easy access for the user.
Please ensure that cradle is screwed rmly onto the wall using the screws provided.
F6 Operating the Appliance
If you haven’t done so already, insert the supplied “AA” size batteries, being careful of the
polarity.
You should now see on the display of the remote the time showing “0:00”.
To turn the re on, press the “POWER” button once, and within a few seconds the appli-
ance will begin its startup sequence.
NOTE: The appliance begins its startup with a 15 second pre-start purge, where the
combustion fan runs on its own to clear the rebox before it tries to ignite. During the
pre-purge the remote will alternately show the remote’s “Set” temperature and a rotating
segment indicator to show that the re is in start up mode and will try to ignite.
When the appliance has lit, set the room temperature by pressing the ‘plus’ or ‘minus’
buttons repeatedly until the display is showing the desired temperature. The remote will
then revert back to the ‘current’ room temperature 30 seconds after making the change.
Run the appliance on full for an hour with the windows and doors open in the dwelling.
This will ensure any running-in smells have the chance to dissipate.
The appliance is turned o by pressing the “POWER” button once more. The remote will
display the time only.