Service manual

B
ACDE
FGSERVICE
35
F4 Fitting the Fascia Panels
To avoid scratches or knocks to the fascia panels of this heater they must be tted at the
complete conclusion of the installation process, after wall linings are in place.
Note: Never ever rub the fascia.
Step 1: Ensure the plastic spacer is placed on
the thread of the studs.
Step 2: Screw and tighten the 4 studs with
spacers onto the back of the fascia
Step 3: Rivet the 4x spring clips onto the chassis
of the appliance as shown
Step 4: After the 10mm thick wall has been
nished, the fascia clips onto the appliance as
shown.