Service manual

B
ACDE
FGSERVICE
33
F
Finishing the Installation
F1 Crystalite, Coal, or Driftwood Fuel Bed Installation
If using the crystalight, coal, or driftwood fuel beds, rst place all the Crystallite/Coal
pieces in a single layer atop the Burners and Fuelbed Tray. Cover the entire area except for
the pilot shield, ensuring coverage right up to both glass windows and rear of rebox for
single sided.
If the Driftwood fuelbed style has been chosen, follow the above directions for placing
the Crystallite and then place the Driftwood pieces randomly atop the Crystallite layer.
Ensure the wood pieces are spread out across evenly and not over the pilot assembly.
Do not heap or mound any fuelbed. Continue onto following page >
F2 Log and cone Fuel Bed (Woodland Selection)
If using the Logs and cones with Shale (chips) fuel bed, rst place the logs and cones in
the positions as shown below.
Once the logs and cones have been correctly positioned, scatter the Shale (chips)
fuel bed media evenly across the re base to cover as much area as possible without
obstructing the pilot ame.
For the DX1000 you should use the 7x supplied 600ml bags of shale (chips), and for the
DX1500 you should use the 10x supplied bags.