Service manual

B
ACD
EFGSERVICE
31
E10 Auxillary On/O button
The auxillary on/o button is
used to turn the replace on
without the Remote Control,
and also used for “teaching”
the replace to listen for new
remote controls. For information
on teaching a new remote
control, see section S4 of the
service manual at the end of this
document.
The auxillary On/O button is
accessed by using an allen-key
or thin object to poke through in
the location shown to the right.
E11 Home Automation Setup
Escea D-Series replaces have a simple interface for connection to a home automation
system. Simply put this allows the replace to be woken up and started and then shut
down. The “Close to wake” connection shown is essentially taking one of the 3.3 volt DC
pins on the replace micro controller and pulling it down to ground. In order to isolate
the replace from the automaton system a relay needs to be used as shown. This allows
you to use any nominal voltage to drive the relay while keeping the replaces 3.3V supply
isolated.
μ
Terminal block
Connector
on fireplace
Fireplace
Connector and terminal
block supplied by Escea
+3.3VDC
From Automation system
Required relay
Note: you will need to match the relay coil voltage with the voltage from your automaton
system.
The Home Automation connection can
be found in your replace accessory
pack and is shown to the right.
This connects to the replace via the
removable access panel in the bottom
right of the replace, as shown in
section C2.