Service manual

Warranty Repair and Annual Servicing:
Warranty repair work must be carried out by a recognised Escea gas replace technician.
It is recommended that recognised Escea Gas Fireplace Technicians are also used to carry
out annual servicing requirements (particularly during the warranty period). For contact
details of authorised Escea Gas Fireplace Technicians in your area, please contact the
retailer from whom the appliance was purchased.
General installation information:
This appliance must be installed according to these instructions and in compliance with
all relevant building, gas tting, electrical and other statutory regulations (eg. AS/NZS
5601.1). Any shortcomings in the appliance and ue installation will be the responsibility
of the installer, and Escea will not be accountable for any such failings or their conse-
quences.
Once this appliance is installed it cannot be removed without disturbing the wall lining.
This DX Series replaces has been dispatched from the factory set as a single sided ver-
sion. This can be converted into a double sided appliance by using the Double Sided
Conversion Kit available from your Escea distributor. Conversion details are shown in
Section E.
An electrician is required to install a 3pin power socket – Section C