Service manual

B
ACD
E F G SERVICE
24
E
Installing the Appliance
E1 Double Sided conversion
If the appliance is to be double sided,
you will have been supplied with an extra
glass panel and steel support frame and
wall lining trim brackets.
1. On the rear of the appliance, unscrew
the outer shell cover and remove it as
shown
2. Unscrew the Firebox rear panel and
remove it. Sometimes extra force may
be required to remove this panel as the
sealing tape can ‘glue’ itself to the painted
surface.
3. Screw the Wall Lining trim brackets
on to the appliance chassis as shown in
photo.
4. Carefully install the extra glass panel
and frame onto the appliance, ensuring
that the glass does not fall from the frame.
Tighten the bolts around the outside of
the glass retainer until securely tted.