Service manual

B
A C D E F G SERVICE
14
B13 Duct Fan mounting
Using the 3x spring mounts supplied, the duct fan should be installed in one of the
following positions as shown below. You must use the spring mounts as this will help
decrease noise by not transferring vibration into the walls.
Run the electrical cable from the duct fan to the cavity where the appliance will be in-
stalled. Ensure the cable is not draped over or in contact with the outer shell of the appli-
ance or either of the exi ue tubes and kept clear from any other possible heat sources.
Fix it appropriately and allow enough cable loop to prevent tension on the cable plugs.
The duct fan unit length is approx 350mm and diameter is approx 340mm.
END OF SECTION B
By the end of this section, you should have:
 A framed, but un-lined, cavity sized to suit your fascia and ue conguration
 Provision for sucient access to the powerue for future servicing