User guide

− Cleaning the logs / Glass (DL series):
Step 1: If using a Velo or Rado fascia, Remove the lower trim which is
held in place by magnets
Step 2: Lift o the inner fascia by unscrewing the base of the inner
fascia, then pulling it out and lifting it up and o.
Step 3: Unscrew the top and side glass retainers and remove them.
Take care that the glass does not fall forwards at this stage.
Step 4: Lift out glass and place it carefully aside.
Step 5: Take out log set and gently brush any soot from log with a
soft hearth brush. The burner tops can be vacuumed too.
Step 6: Clean the inside and outside of glass with normal glass
cleaning products. Use a clean dry cloth only. Stubborn marks
may be cleaned with a ceramic glass cleaner.
Step 7 : Replace in opposite order and test run heater.
Step 2
Step 3