Service manual
B
ACDEFGSERVICE
39
F5 Locating Wall Mount Cradle for Wireless Control:
The appliance’s remote contains the thermostat that will sense the room temperature
and communicate this back to the heater via radio frequency.
A wall mount cradle has been provided for the wireless control and where possible the
control should be housed in this cradle.
The location of this cradle should be decided by taking into account the following factors;
Simple, convenient access for the user
Away from air ow and drafts through the room
The parts of the room that people are likely to spend time
Away from direct sun light
A suitable distance away from the heater.
Ideally 1.2m to 1.5m from the oor
The radio frequency signal will go through some walls but for best results Escea suggest
that the cradle position is between 1 and 5 metres away from the heater.
Please ensure that cradle is screwed rmly onto the wall using the screws provided.
F6 Operating the Appliance for the First Time:
Remove the battery cover on the rear of the remote. Insert the new “AA” size batteries,
paying attention to the polarity.
You should now see on the display of the remote the time showing “0:00”.
To turn the re on, press the “POWER” button once, and within a few seconds the appli-
ance will begin its startup sequence.
NOTE: The appliance begins its startup with a thirty second pre-start purge, where the
combustion fan runs on its own to clear the rebox before it tries to ignite. During the
pre-purge the remote will alternately show the remote’s “Set” temperature and a rotating
segment indicator to show that the re is in start up mode and will try to ignite.
When the appliance has lit, set the room temperature by pressing the ‘plus’ or ‘minus’
button repeatedly until the display is showing the desired temperature. The remote will
then revert back to the ‘current’ room temperature 30 seconds after making the change.
Run the appliance on full for an hour with the windows and doors open in the dwelling.
This will ensure any running-in smells have the chance to dissipate.
The appliance is turned o by pressing the “POWER” button once more. The remote will
display the time only.
Run the appliance again and check the operation of the thermostat by increasing and re-
ducing the set temperature. Check the Flame Eect function and the Fan Boost functions
work correctly.
For further operation instructions please refer to the User Guide.