Service manual

B
A C D E F G SERVICE
38
Step 7: Attach the inner fascia brackets to the
Inner Fascia as per the instruction page sup-
plied with the fascia. Hang the top edge of
the Inner Fascia from the lip that extends at
45 degrees from the top of the rebox. This
fascia is attached to the re at its base by two
screws. Leave the screws loose enough to be able
to adjust the Inner Fascia.
Step 8: Check that the Inner Fascia is
centred. If this panel is not centred,
adjust the Inner Fascia side to side un-
til the spaces on either side are even.
Tighten the screws to x the Inner
Fascia in place.
Step 9: Push the supplied magnet brackets into position. Place the bottom fascia trim
onto the magnets. If this panel does not t, adjust the outer fascia side to side or the ap-
pliance in/out until the trim ts well.