Service manual

B
ACDEFGSERVICE
37
Step 4: Attach the lower foot to the fascia by screwing it in the positions shown below.
S
TEP 4
STEP 5 + 6
STEP 7 + 8
STEP 9
Step 5: Hang the Outer Fascia from the magnet bracket attached to the top of the re-
box. Insert the fascia so that it is parallel with the front of the gas replace. The Hex-nuts
attaching the magnets to the fascia will locate in the holes on the magnet bracket, secur-
ing the Outer Fascia in the correct position. If this fascia does not t, check to make sure
the magnet bracket installed above is in the correct orientation.
Step 6: Fit the two screws at the base of each side of this fascia. The heater may have to
be adjusted in or out of the cavity to ensure fascia ts correctly.