Service manual

B
ACDEFGSERVICE
31
F
Fitting the Fascia and Finishing Installation
F1 Fitting the Fascia Panels:
To avoid scratches or knocks to the fascia panels of this heater they must be tted at the
complete conclusion of the installation process. It may be necessary to use the outer
fascia to initially locate the heater but then remove it again so that there is no chance of
damage. Use the soft gloves provided whenever handling the fascia.
There are four fascia types available with the DL850 / DL1100:
Velo (4 Sided)
Rado
Quadrato
Quadrato Lite
The fascia installation will depend on the fascia and cavity type. For:
Velo Four Sided, see section F2
Quadrato / Quadrato Lite, see section F3
Rado, see section F4
Never, ever rub the fascia panels. Refer to cleaning instructions supplied with fascia.