Service manual

B
A C D E F G SERVICE
24
E7 Removing the Glass
Unscrew the top glass retainer
bracket and the two side glass
retainer brackets. Take care
that the glass does not fall
forward at this stage.
Pull the top of the glass toward
you slightly and lift the glass
out of the bottom glass re-
tainer. You may need to tilt the
glass to achieve this.
Place the glass carefully aside.
Note that the breglass tape
around the glass can mark
carpet and furnishings.
E8 Converting the Appliance Gas Type
This appliance has been factory set to operate on Natural Gas only. To convert the appli-
ance to operate on propane or ULPG, proceed as follows:
□ Remove the small perforated shroud on the right hand side of the rebox.
□ Remove the 2 screws securing the burners in place and lift out the burners as shown.
□ Remove the 2 screws securing the pilot guard shown below and lift it out.
Jets DL850 Front DL850 Rear DL1100 Front DL1100 Rear
NG Ø2.45mm Ø2.3mm Ø2.6mm Ø2.6mm
Propane Ø1.4mm Ø1.3mm Ø1.4mm Ø1.3mm
ULPG Ø1.2mm Ø1.1mm Ø1.3mm Ø1.2mm
□ Remove the front burner jet and replace with the correct jet as stated in the above
table.
□ Remove the 2 screws securing the Pilot Cover Plates and slide these out as shown on
following page.
□ Remove the 4 screws securing the pilot bracket and lift out the bracket and pilot hood
assembly.
□ Remove (un screw) the existing pilot jet and replace with the jet marked red supplied
in the conversion kit.