User manual

2 WARRANTY

0463 373 101

- 7 -

2 WARRANTY

Before delivery, our products are carefully checked. ESAB verify that each product is free

from defects of material and workmanship at the time of delivery and is functioning according

to its intended use.

ESAB provides warranty on defects of material and workmanship according to legal

requirements. Consumables are exempt from this warranty.

The warranty does not cover any damages or functional defects resulting from:

• overloading, abusing or diverting from intended use of the product

• collisions or accidents

• non compliance with instructions stated in these operating instructions

• improper installation or assembly

• insufficient maintenance

• modifying the product from its original state

• chemical influences

• normal wear and tear

ESAB assumes no liability other than for replacement or repair of faulty parts.

2.1 Conditions of intended use

1. The product is intended for industrial and commercial use and must only be utilized by

trained personnel. The manufacturer is not liable for any damage or accidents resulting

from improper usage.

2. The ESAB RT Robo welding system is designed and produced at the state of the art and

is safe and reliable in operation when handled, installed and maintained by trained

personnel. The instructions for installation, operation and maintenance described in this

document must be followed.

3. The ESAB RT Robo welding system may only be installed, operated and serviced by

trained personnel. The installation, operation, and maintenance regulations detailed in

this manual are to be followed.

4. The ESAB RT Robo welding system may solely be used for the purpose intended by the

manufacturer within the framework of its technical data and with automated handling

systems. The type of torch must be selected to suit the welding task.

5. The ESAB RT Robo welding system was designed for use as a complete system. The

incorporation of components from other manufacturers into the system is not permissible.

6. The torch mount KSC-2 is only to be used as an emergency stop mechanism within its

technical specifications and in combination with an Infiniturn or Helix cable assembly,

ESAB adapter flange and an Aristo RT welding torch.

7. No oil or anti-spatter fluid should be added to the blow-out gas. ESAB does not

guarantee chemical resistance to those substances. ESAB recommends using the ESAB

spraying unit to apply the minimum amount of anti-spatter fluid to the torch and therefore

protecting the environment.

8. The product must be kept dry and protected from humidity when transported, stored or

used.

9. The system is designed for environmental temperatures range from 5 °C to 40 °C (41 °F

to 104 °F). In case these limits are exceeded, specific action is needed. In case of frost

risk, use a suitable coolant.