User manual

5 INSTALLATION

0463 373 101

- 28 -

6. If present insert the control cable plug (10) into the connector (11) and make sure it is

firmly seated.

7. 3× M5×35 screw

8. Washer

10. Control cable plug

11. Control cable connector

12. 2× Micro switch

13. Index pin

7. Gently push back the cable assembly into the robot arm and carefully seat the KSC-2 or

FLC-2 cover (1) in place. Observe the index pin (13) to be in the correct position. Make

sure the two micro switches (12) are not damaged if present.

8. Insert the three M5 screws (14) and tighten without excessive force.

13. Index pin

14. 3× M5×12 screws