User manual

5 INSTALLATION

0463 373 101

- 27 -

4. Insert the coupling (2) into the socket of the cover (1) as shown. Align the index pin (6)

with the index hole (5) in the main body and insert completely.

NOTE!

Take great care that the position of the O-rings is not shifted by the index pin

during the assembly.

1. KSC-2 / FLC-2 cover

2. Coupling

3. KSC-2 / FLC-2 main body

4. 3× O-ring for water cooled systems; 4a. O-ring for gas cooled systems

5. Index hole

6. Index pin

7. 3× M5×35 screws

11. Control cable connector

5. Insert the three screws (7) with the associated washers (8) and tighten gently with the

enclosed hexagonal wrench, see below illustration.

Do not use excessive force! (approximately 2 Nm (18 lbf in))