User manual

5 INSTALLATION

0463 373 101

- 20 -

5.3.1 Torch mount in standard RT system

5.3.1.1 Direct mounting of KS-2

1. If necessary, carefully press the cylindrical pins (1) into the corresponding holes in the

bracket. Avoid the formation of burrs. The pins should protrude by approximately 5 mm

(0.2 inch).

2. Position the mount on the safety-off mechanism KS-2 and carefully insert the cylindrical

pins (1) into the holes provided. In doing so, take the later position of the torch into

account. Two mounting positions may be potentially possible.

3. Then screw down the mount evenly using the enclosed cylinder screws with hexagon

socket (2).

NOTE!

The maximum tightening torque for the cylinder screw (2) is 6 Nm (53 lbf in)

and the property class category is 8.8.

Side view

1. Cylindrical pins Ø4×20

2. Cylinder screw with hexagon socket M6

DIN 912 (length of the screw depending

on the torch mount)

5.3.1.2 Mounting via mounting flange

Torch mounts with a central clamping assembly can only be fastened on the journal of the

mounting flange. For this, the mounting flange must be fastened first.

1. If applicable, carefully press the cylindrical pins (1) into the corresponding holes in the

mounting flange. Avoid the formation of burrs. The pins should protrude by

approximately 5 mm (0.2”).

2. Position the mount on the safety-off mechanism KS-2 and carefully insert the cylindrical

pins (1) into the holes provided. In doing so, take the later position of the torch into

account. Two mounting positions may be potentially possible.

3. Then screw down the mounting flange evenly using the enclosed cylinder screws with

hexagon socket (2).

NOTE!

The maximum tightening torque for the cylinder screw (2) is 7.1 Nm (62.8 lbf

in) and the property class category is 8.8.

4. Unscrew the axial cylinder screw with hexagon socket (4) out of the mounting flange

together with the washer (3).