Instruction manual

30
5.6) Lifting
To move the feeder around the workplace use a hook, use the lifting eye for lifting, P/N.: 0401231 according
to the picture below.
5.5) Installing the wire in the Brake Hub
The hub is adjusted when delivered, if readjustment is required, follow the instructions below. Adjust the
brake hub so that wire is slightly slack when wire feed stops.
Adjusting the braking torque:
Turn the red handle to the locked position.
Insert a screwdriver into the springs in the hub.
Turn the springs clockwiseto reduce the braking torque.
Turn the springs counterclockwiseto increase the braking torque.
¡
¡
¡
¡
N.B.: Turn both springs through the same amount.
NOTA:In order to latch or unlatch, just turn the red handle. There´s no need to
remove it.
Picture 1 Picture 2
Origo Feed 304 P2
P3
P4
™
Origo Feed 304
Origo Feed 304
™
™