User manual

-- 4 4 --
dha2d1ea
ARC WELDING MIG/MAG
S Connect the control cable ( 6) between the power source (7) and control box
PEG1.
S Connect the return cable (8, 9, 10) between the power source (7) and work
piece.
S Connect the cable (8, 9, 10) between the power source (7) and shunt.
S Connect the measurement cable (11) between the power source (7) and
work piece.
S Connect the gas hose (4) between the reducer valve (5) and the gas
connection (1) on the welding machine.
S Connect the cooling water hoses (2) between the cooling unit (3) and the
welding machine (1).
3. Choose the wire and flux (gas) to give a weld metal analysis that matches the
work piece fairly closely. Choose the wire size and welding parameters in
accordance with the recommendations of the consumable manufacturer.
4. Loading with welding wire.
S Remove the wire reel from the hub (2) and remove the
end plate (3).
S Place the coil of wire (1) on the reel and fit the end plate (3).
S Fit the wire reel and disposable reel on the hub (2).
NOTE the position o f the stud.
IMPORTANT!
To prevent the reel sliding off the hub: Lock the reel in place
by turning the red knob as shown on the warning label atta-
ched next to the hub.
GB