User manual
Table Of Contents
- 1. Introduction
- 2. Technical data
- 3. For your safety
- 4. Transport, storage and disposal
- 5. Commissioning
- 6. Functional description
- 6.1 Operation
- 6.2 The Work mode
- 6.3 Parameter mode
- 6.4 Configuration mode
- 6.5 Factory settings (“default”)
- 6.6 Contrast
- 6.7 Replacing the soldering tip
- 6.8 Changing the Heating Element
- 6.9 Sensitive components
- 7. Error diagnosis and remedy
- 8. Maintenance
- 9. Replacement parts
- 10. Warranty
i-CON 1 / 43
3BA00180 • 28.04.2008 • Rev. 1
Operating instructions
8. Maintenance
8.1 Important care jobs
To ensure a long service life of your station, a few points must be observed.
■
Make sure that the soldering and desoldering tip is always tinned. A
soldering tip which is always clean will become passive within a short
time. If you always leave a small amount of solder at the soldering tip
when you stop soldering, the service life increases substantially.
■
If necessary wipe the soldering tip only just before the start of the sol-
dering process.
■
To obtain good electrical and thermal conductivity, occassionally
remove the soldering tip and clean the heating element shaft with a
brass brush.
■
Make sure that the effectiveness of the ventilation holes is not im-
paired by a build-up of dust.
Only use genuine ERSA consumables and spare parts to ensure reli-
able functionality and warranty!
Warning!
There are no parts to be maintained within the device!
8.2 Cleaning
Occasionally clean the device with a moistened soft cloth. Steam cleaners, pressure
washers, scrubbing sponges, abrasives, solvents like alcohol or benzine must not
be used!