User manual
Table Of Contents
- 1. Introduction
- 2. Technical data
- 3. For your safety
- 4. Transport, storage and disposal
- 5. Commissioning
- 6. Functional description
- 6.1 Operation
- 6.2 The Work mode
- 6.3 Parameter mode
- 6.4 Configuration mode
- 6.5 Factory settings (“default”)
- 6.6 Contrast
- 6.7 Replacing the soldering tip
- 6.8 Changing the Heating Element
- 6.9 Sensitive components
- 7. Error diagnosis and remedy
- 8. Maintenance
- 9. Replacement parts
- 10. Warranty
i-CON 1 / 39
3BA00180 • 28.04.2008 • Rev. 1
Operating instructions
7.2 Other Errors
Other errors may also occur, indicating possible defects in the soldering tool. These
errors are:
• The station permamently only displays the room temperature. This
indicates a fault on the heater or in the supply line.
If the station is in idle state, the room temperature will also be dis-
played after a few minutes!
• The display is switched off and no longer displays anything, but the
mains switch continues to be illuminated. In this case, the soldering
station is overloaded. Once the soldering station has cooled down suf-
ciently(approx.30minutes),workcanbecontinued.