User manual
Table Of Contents
- 1. Introduction
- 2. Technical data
- 3. For your safety
- 4. Transport, storage and disposal
- 5. Commissioning
- 6. Functional description
- 6.1 Operation
- 6.2 The Work mode
- 6.3 Parameter mode
- 6.4 Configuration mode
- 6.5 Factory settings (“default”)
- 6.6 Contrast
- 6.7 Replacing the soldering tip
- 6.8 Changing the Heating Element
- 6.9 Sensitive components
- 7. Error diagnosis and remedy
- 8. Maintenance
- 9. Replacement parts
- 10. Warranty
i-CON 1 / 38
3BA00180 • 28.04.2008 • Rev. 1
Operating instructions
7. Error diagnosis and remedy
7.1 General Errors
If the soldering station does not operate as expected, check the following items:
• Is main voltage present? Correctly connect the mains lead to the de
-
vice and socket.
• Is the fuse defect? The fuse can be found at the rear side of the de
-
vice in the mains connecting socket.
• Note that a defective fuse may also indicate a deeper cause of error.
Simplychangingthefusethereforegenerallydoesnotsufce.
• Is the soldering tool correctly connected to the supply unit?