User manual
Table Of Contents
- 1. Introduction
- 2. Technical data
- 3. For your safety
- 4. Transport, storage and disposal
- 5. Commissioning
- 6. Functional description
- 6.1 Operation
- 6.2 The Work mode
- 6.3 Parameter mode
- 6.4 Configuration mode
- 6.5 Factory settings (“default”)
- 6.6 Contrast
- 6.7 Replacing the soldering tip
- 6.8 Changing the Heating Element
- 6.9 Sensitive components
- 7. Error diagnosis and remedy
- 8. Maintenance
- 9. Replacement parts
- 10. Warranty
i-CON 1 / 10
3BA00180 • 28.04.2008 • Rev. 1
Operating instructions
Warning! Protect connection cables. Do not use the connection cable
to pull out the plug or as a means of carrying the device. Make sure
that connection cables are not exposed to heat and do not come into
contact with oil or sharp edges. Damaged connection cables represent
apotentialcauseofre,short-circuitsandelectricshocks.Damaged
connectingcablescancausere,shortcircuits,andelectricshock,
consequently they must be replaced immediately.
Attention! Take account of ambient conditions. Protect your device
against all liquids and moisture. Failure to do this represents a risk of
reorelectricshocks.
Caution! Look after your heating tool. Always keep your ERSA prod-
uct in a safe, dry place out of the reach of children. Pay attention to
any maintenance requirements. Check your device at regular inter-
vals. Always use genuine ERSA accessories and spare parts.
Attention! Physically and/or mentally disabled people may only use
the soldering station when supervised by trained expert personnel!
Children are not allowed to play with the soldering station!
National and international regulations
Comply with national and international regulations governing health
and safety at work.