Installation Guide

35
RAM
F
Mount the replacement Ehubo on the existing mount using
the screws and washers (F) supplied with the replacement
Ehubo.
9
Pull the sticker and screen protection film o the
Ehubo screen.
10
The install wizard must be re-run to completion on the new
unit. Follow the instructions on the screen to complete the
installation. (See the Install Wizard instructions in previous
chapters for more information.) The installation is complete
when the Ehubo Home screen is displayed. This is the end
of the process.
11
Please place the uninstalled Ehubo in the replacement box
and return to EROAD, including any surplus parts.
12
U
T
K
S
Insert the two rear
hatch screws (S) and
new security plugs (K),
if applicable.
Slide the replacement Ehubo’s
rear hatch (T) onto the cable
grommet (U) and insert it into
the replacement Ehubo.
7 8
You must rerun the Install Wizard when the Ehubo is powered
ON. Perform these steps if the system does not prompt you to
complete the Install Wizard.
• Press and hold the EROAD logo on the top left corner
of the Home screen for seven (7) seconds to access the
Diagnostics Mode screen. Alternatively, press and hold
Login if no one has logged into the Ehubo.
• Tap Install Wizard once the Diagnostic Mode screen
appears. Follow the applicable installation procedure for
your vehicle.