Installation Guide
17
9. The Ehubo is now testing the external power source to ensure
that the device is receiving the proper voltage from the
diagnostic connector. Tap the OK button.
NOTE: The device might restart if the power supply is not
adequate.
Next, the green check marks on the Installation Complete screen
indicate that the unit has good external power, the wiring checks
are complete, and the system is now ELD ready.
ELD ready means that this vehicle is now ready to be enabled in
Depot to collect electronic logs on the device.
10. Tap the Finished button.
You've just successfully completed the installation wizard. The
following Pending Assignment screen appears until you assign
the Ehubo to a vehicle in the Depot application.
NOTE: Enabling the device is typically performed in the Depot
application by your back oce personnel.
See the Assign an Ehubo to a Vehicle training lesson for more
information.