Installation Guide

16
The Ehubo starts counting down as it receives data from the
ECM. You can watch the seconds tick down until it is ready for
the next step.
The Ehubo displays the system checks on engine speed and
hours, as well as vehicle speed, distance, and VIN. This means that
it has retrieved all required data from the ECM.
This example uses the J1939 protocol, which displays for new
trucks. Vehicles using the older communication standard J1708
would also display data on this screen.
6. Tap the Continue button.
NOTE: Contact EROAD at [e-mail] if you see a red
X rather than green check marks or if the screen displays the
"Something is not quite right" message.
7. Physically turn OFF the truck. Notice the key icon has turned
red, which is located on the upper right corner of the Ehubo.
8. Tap the Engine O button.