User manual

Camera Select and PTZ-Camera Control

The PTZ functions listed below are also available for PTZ cameras remotely connected to the

VST 10CA Fast Scan transmitters; refer to the Operation section in the VST 10CA Manual

Select Camera

If Camera 3 is to be displayed on Monitor number 1 (SYSTEM 500M only):

ðð ðð

ðð

SYSTEM 500M VST 10CA

Select monitor number 1 Select camera number 3 Select channel number 3

Select Camera for PTZ-Control

If Camera 4 is to be displayed and controlled on Monitor number 2:

ðð ðð

Select monitor number 2 Select camera number 4

Take

control

Note:* Note:*

Note*: The MON key should not be used in connection with cameras connected to the VST

10CA, since monitor operation is disabled while controlling Adpro equipment. Cameras

connected to the VST 10CA can be PTZ-operated when displayed without further key strokes.

User Manual for SYSTEM 500M

GB - Page 8 Number 2822-00025