User manual

Key Functions
The keys on the keyboard have the following functions:
KEY DESCRIPTION
1 2 3
4 5 6
7 8 9
0
ESC CLR
The numeric keys are used to select the ID numbers of the monitors and cameras
connected to the system, as well as video sequences, camera prepositions and
remote sites.
The CLR key resets all digits in the status display to 0 (zero).
The CLR key is also used to clear any message displayed on the monitors, except for
the camera text string and alarm messages.
The ESC key is in non-programming mode used for the following purposes:
The key combination ESC
→ DISPLAY TIME give access to adjustment of the clock.
The key combination ESC
→ CLEAR ALARM display the alarm status menu.
The key combination ESC
→ MONITOR set all monitors to default.
The key combination ESC
→ SEQUENCE accesses the sequence dwell time factor.
The key combination ESC
→ PREPOSITION will together with the numerical keys
save a preposition.
The ESC key itself is, when Adpro equipment is controlled, used to activate the
Adpro function "END".
The key combination ESC
+ ↑/↓ is used in connexion with the Adpro VST 10CA to
make CHANNEL UP/DOWN selections.
The key combination ESC
+ ←/→ is used in connexion with the Adpro VST 10CA to
make DISPLAY LEFT/RIGHT selections.
The MONITOR key is used to select a monitor. If monitor No. 1 is to be selected,
press the numeric key "1", and immediately after the key "MONITOR". The
MONITOR key is also used in order to give control over a selected camera. When the
camera has been selected make sure that the status display on the keyboard shows
"0000" and then press the MONITOR key that makes it possible to control this
camera.
The CAMERA key is used to select a camera. If camera No. 1 is to be selected,
press the numeric key "1", and immediately after the key "CAMERA".
The SEQUENCE key is used to select a sequence. If sequence No. 1 is to be
selected, press the numeric key "1", and immediately after the key "SEQUENCE".
The SEQUENCE key is also used to step fast through a sequence, every time the
SEQUENCE key is pressed the sequence will go to the next camera.
The SEQUENCE key is ALSO used to start a pre-programmed sequence of the
camera positions. This function can only be used if Ernitec Preposition Camera
Stations are connected.
The HOLD key is used to stop the SEQUENCE function temporary.
Press once and the sequence stops on the currently selected monitor. Press HOLD
once more and the sequence will start again.
Press and hold down the HOLD key in order to stop all running sequences.
The DISPLAY TIME key is pressed to display TIME and DATE on the monitor.
Pressing the key a second time, TIME and DATE is removed from the monitor.
Used together with the ESC key to get access to adjustment of the clock: If the
time/date should be reset, press the key "ESC", and immediately after the key
"DISPLAY TIME".
?
The HELP key is used display/remove text displayed by the selected Camera Station.
This function can only be used if BDR-55X Camera Stations are used.
In Adpro control, the HELP key is used to display help menus, if any.
The CLEAR ALARM key is used to clear an alarmed picture from the monitor.
Pressing the ESC key immediately followed by the CLEAR ALARM key will access
the ALARM STATUS MENU.
User Manual for SYSTEM 500M
GB - Page 4 Number 2822-00025