Installation manual

Keyboard 1502M/1503M Set-up
In order to start programming press the ESC and MENU keys at the same time and enter the
password (4 digits). The default password is 0000.
In order to exit programming press the ESC key, and the keyboard will automatically be
re-booted in order to activate the new setting(s).
Default settings
The main default settings are factory programmed as follows:
Keyboard type: System keyboard
Communication: ARC NET
Address : 4
Baud rate: 312,50 Kbs
Password: 0000
Change keyboard type
Press the key F4 to toggle between SysKbd or CamCrtl.
Change communication media
Press the key F6 to toggle between ARC NET - RS232 - RS485
Set baud rate
Press the F7 key to toggle between the valid baud rates.
Change of keyboard address
Press the F9 key to get to the Kdb.No menu.
Press the F4 key to toggle between the valid keyboard numbers.
Set the function of the AUX keys
Press the F9 key to get to the AUX menu.
Press the F6 key to toggle between Latch/No Latch/1801M
function.
Change the password
Press the F9 key to get to the Change Password menu.
Press F7 and enter the new password (4 digits).
Re-enter the new password.
Set the volume of the key-press beeper
Press the F9 key to get the Beep menu.
Press the F4 key to toggle between HIGH - LOW - OFF.
Test and re-calibrate joystick
Use this function to re-calibrate the joystick in case e.g. pan & tilts are moving although the
joystick is released.
Press the F9 key to get the Test joystick menu.
Press the F7 key to enter the test and re-calibation functions.
Installation and Setup instruction for Keyboard Series 1500
Page 9