User Guide
RESET
Take out both earbuds from the charging case,
both earbuds will power on and enter paring
mode in which the LED flashes red and blue
alternately.
Settings
DEVICES
Connected
Bluetooth
Bluetooth
Flame Solo
OPERATION GUIDE
2
1
Search Bluetooth name
“ Flame Solo ” and
select it in your mobile
phone.
AUTO PAIRING SETUP
X1
S
X1
XS
X1
M
X1
L
1
Choose the perfect size for you
3
Give a slight twist to
lock them in your ear
2
Align and Assemble
4
1. Turn off your device’s Bluetooth function.
2. Take out both earbuds from the charging case and the earbuds will automatically enter into the
pairing mode in which LED flashes blue and red alternately.
3. Simultaneously keep pressing both volume up and volume down buttons of either earbud for
3 seconds.
4. The paired information will be cleared and the earbuds will be off.
Q&A
Note: Remove the insulating film on the charging connectors on both earbuds
before charging it.
Q1：Why doesn't music stop when I put Flame Solo back into the case .
Q2：How to know the remaining battery of the charging case?
Reason 2: The charging case is out of battery.
Solution:
1. To recharge the case.
2. Or manually turn off the earbuds by keeping clicking the buttons on both earbuds
for 5 seconds. The earbud’s light will keep on for 1 second and then goes out.
with the voice prompt “Power off”.
When you open or close the case, you will know the battery level by checking
the indicator:
Solution: Reset the earbuds by following the steps as previously mentioned.
Q3: How to know the charging status and the full power status of the case?
Q4：How to operate if the Bluetooth disconnect or fail to reconnect?
Blue LED flashes
4 LEDs keep steady on
Charging Full power
Left(L) or Right(R)
Left(L) or Right(R)
BUTTONS CONTROL
or
OFF
R
L
Hold on 3s
Settings
Bluetooth
Bluetooth
Battery Level LED light
0%-25%
50%-75%
75%-100%
25%-50%
Play/Pause ：Click the MFB
Answer or Hand up：Click the MFB
Reject a call：Press and hold the MFB for 1 second
Activate Siri or Assistant：Double click the MFB
Volume + : click “+” once.
Next track: press and hold “+” for 1 second.
Volume -: click “-”once.
Previous track: press and hold “-” for 1 second.
Reason 1: Earbuds might not be placed properly and not in the status of charging.
Solution: Make sure Flame Solo is being properly placed.