Installation Guide

1. Find the correct frame pieces.
Matching each letter to corresponding
one:
2. Insert the brackets into the frame and make
sure the pin gets into the hole.
3. Tighten the brackets screws equally
until there is no gap between frames.
4. For low bottom track, use the longer
screws that came with frame and screw
from behind the side pieces into the
bottom track.
Frame Assembly
Once frame is assembled, place it by the installation
location and check the opening size and Floor level
• Recommended opening size is overall frame size
+1/2” .
• Check the door’s spec sheet to make sure frame
is facing the correct way.
• For outswing door, hinge holes will be toward
outside of your building and wider side of frame
will be toward inside.
• For Inswing door, hinge holes will be toward
inside of your building and wider side of frame
will be toward outside.
• Drain holes in bottom track should always face
outside.