Installation Guide

Installation Guide

STEP II. Countertop Preparation

As is shown in the left illustration, the recom-

mended support frame should be fabricat-

ed as follows:

Construct a framework that consists of two

horizontally and four vertically extending

wooden supports, as shown in the illustra-

tion.

Then craft a supporting board with a drain

outlet clearance hole cut out on it; put the

board on the top of the frame.

Ensure the distance from the top of the

supporting board to that of the cabinet is

identical to the maximum height of the sink;

allow adequate clearance for the water

supply lines.

After proper positioning, secure the support

frame to the cabinet.

TIP Use clamps to hold the supports in

position and secure the supports with

construction adhesive and screws.(not

provided)

Measure and sketch the cut-out area

according to the measurements taken

from the actual sink.

Cut the countertop.

STEP III. Cabinet/Support Frame

Construction and Installation

NOTE Securing hardware should be positioned with consideration of easy removal

in case the sink needs to be removed; due to the variety of installations possible with

this sink, your installer may suggest a different support frame design.

Cut-out Area of the Countertop

Frame Members

Support

Water Supply Lines

Drain Hole