Installation Guide

Safety

Glasses

Tape

Measure

SealantDrill

Hacksaw

/Jigsaw

Plus：

Hole Saw

Support Framing Material

Sanding Block

Spirit Level

Painter’s Tape

Shims

Cabinet Fillers

Clamps

Denatured Alcohol

Screws

1. Observe all local plumbing and building codes.

2. Shut off the hot and cold water supplies. Inspect the drain and supply tubing.

Replace if necessary.

3. Unpack the new sink and inspect it for damage. Afterward, return the sink to its

protective carton until the installation begins.

4. In consideration of various installations possible with this sink, procedures other

than those described in these instructions may be used.

5. It’s recommended to provide the actual sink to all contractors involved in the

project. It’s critical that all contractors maintain communication and coordinate the

requirements of the project.

6. The cabinet and frame shown in the illustration diagrams are generic and may

not represent the actual design and structure.

7. It is recommended that the sink installation be performed by professional and

experienced installers. For the sake of safety and a damage-free installation, the

sink should be installed by at least two people.

Tools and Materials

Pencil

Construction

Adhesive

Before You Begin

Read the following instructions carefully before you begin

this installation:

Installation Guide