User`s guide

MBR W40 – Admin’s Manual

 Enable Automatic Cleanup of Old Unused UPnP Services Select this check-box to enable automatic cleanup

of invalid rules. This feature checks the validity of all UPnP services every 5 minutes, and removes old and

obsolete services unless a user-defined rule depends on them (see chapter Section  ).

 WAN Connection Publication W40 will publish only one WAN connection.

3.8.3.4 Remote Administration

It is possible to access and control W40 not only from within the home network, but also from the Internet. This

allows you to view or change settings while travelling. It also enables you to allow your ISP to change settings or help

you troubleshoot functionality or communication issues from a remote location.

Note: Remote Web Administration disabled in default system configuration

Remote access to W40 is blocked by default to ensure the security of your home network. However, remote access is

supported by the following services, and you may use the Remote Administration screen to selectively enable these

services if they are needed. To view W40 remote administration options, click the Management menu item under the

System tab, or the Remote Administration icon in the Advanced screen. The Remote Administration screen appears.

Figure 119: Remote Administration

Allow Incoming Access to Web-Management - Used to obtain access to the WBM and to all system settings and

parameters using a browser. Both secure (HTTPS) and non-secure (HTTP) access is available.

Allow Incoming Access to the Telnet Server - Used to create a command-line session and gain access to all system

settings and parameters (using a text-based terminal).

Note: Web Management and Telnet may be used to modify settings of the firewall or disable it. The user may also

change local IP addresses and other settings making it difficult or impossible to access the gateway from the home

network. Therefore, remote access to Telnet or HTTP services should be blocked and should only be permitted when it

is absolutely necessary.

Diagnostic Tools – The tool is used for troubleshooting and remote system management by you or your Internet

Service Provider. The utilities that can be used are Ping and Traceroute (over UDP).

3.8.3.5 TR-069

CWMP (TR-069) defines an application layer protocol for remote management of W40 and provides the

communication between a Customer Premises Equipment (CPE –W40) and an Auto Configuration Server (ACS).

Go to System > Management > TR-069 to configure CWMP capabilities on the W40 system.