System information

221 02-FGB 101 544 Uen H – June 2009 33
6.1.3 Analog Settings Profile
The analog settings profile defines physical settings for the FxS ports
including impedance and nominal gain settings.
6.1.4 CLIP Country Profile
The CLIP country profile includes local settings for the CLIP service.
6.2 General Telephony Features
The following subsections describe telephony related features that can be
customized in the Ericsson W35.
6.2.1 Inter Digit Timer
The Inter Digit Timer (IDT) specifies the duration the Ericsson W35 waits to
detect the next digit when dialing. After this period, no more digits are
expected to arrive and an attempt to establish the call is done.
6.2.2 Dial Tone Timeout
The dial tone timeout specifies for how long the system will wait for the
caller to input the first digit after going off-hook.
6.2.3 Congestion Tone Timeout
The congestion tone timeout determines for how long a congestion tone is
to be played.
6.2.4 Local Ringing Timeout
The local ringing timeout specifies the maximum time a call will attempt to
connect if the B-Party does not answer.
6.2.5 DTMF Duration
This setting determines the DTMF digit signal duration for the regenerated
DTMF signals from the network side towards the POTS port.
The duration of the DTMF-tones sent from the Ericsson W35 towards the
network is determined by the TE and the network settings and is not
configurable in the Ericsson W35.
6.2.6 Howler Tone
The howler tone, used in some countries, is an information-tone of
increased intensity that is intended to alert telephone users of the fact that
they have left the receiver off the hook.
It is possible to configure when the howler tone should start to play in
relation to the start of the previous tone (i.e. busy tone).
6.2.7 On/Off-hook Timeouts
These settings determine the time needed for the Ericsson W35 to consider
the phone to be on- or off-hook.