System information

42 221 02-FGB 101 544 Uen A - September 2008
Transmitted/received current and previous
month.
WAN interface (WUI)
Signal strength (visual quality bars)
(3)
Link status; Up/Down
Mode
Type of connection
Service provider
APN
Network registration
IP address
DNS IP addresses
Traffic statistics; Transmitted and received
packets
Error, Overruns and Dropped packets
Transmitted/received current and previous
month.
(1)
The “Average CQI” (Channel Quality Indicator) is only displayed when a
HSPA link is up and running (has downlink traffic).
(2)
The “Strongest cells” part shows signal information for the three
strongest cells that the unit currently uses for connection.
(3)
The visual signal quality bars are not only based on signal strength
(RSCP). It also takes the EC/I0 (energy to noise and interference ratio),
since the bandwidth is depended on both values.
9.5.4 WAN Interface Statistics
The following information about WAN interface statistics can be displayed
from the CLI:
WAN interface
statistics (CLI)
RSCP values (dBm)
EC/IO values (dB)
A value for each 15 minutes interval for 24
hours (24 hour clock) is displayed. For each
daily interval for 1 month the minimum,
average and maximum value is displayed.
An RSCP threshold can be configured and when the current RSCP level is
below the configured alarm threshold, an alarm is raised and sent to both
syslog and remote syslog.
9.5.5 IPsec/VPN Tunnel State
The following information about a configured IPsec/VPN tunnel can be
displayed:
IPsec tunnel status
UP / DOWN
9.5.6 Firewall Status
The firewall status information (in the CLI) shows all configured firewall
rules and packets per rule.